Start with a clearly defined scope.
An opening is more than a line on a floor. Tell us what needs to pass through it, what must remain intact and how the space is used. We review concrete cutting requests for renovations, utility installation and removal boundaries, with cutting, breakout and disposal priced as clearly identified parts of the job.
Typical project requests
- Slab and pavement cut lines
- Wall and floor openings
- Perimeter cuts before removal
- Cutting combined with haul-out
What to send for an estimate
The more accurately the request describes the site, the more useful the scope review can be. Mark uncertain dimensions or conditions as unknown rather than treating them as confirmed.
- Cut length and layout
- Slab or wall thickness, when known
- Reinforcement or scanning records
- Indoor or outdoor access
A planning detail that matters
An accurate cut location is only one part of the plan. Embedded utilities, structural reinforcement, access to the underside and management of water or slurry need to be addressed before the cut is released.
Make the handoff clear.
Tell us who controls the property, which adjacent areas remain in use and who handles the work before and after this scope. Removal, disposal, replacement, permits, engineering and specialty services should be identified separately in the written proposal.
Before you request pricing
Can I send photos before a site visit?
Yes. Email wide site views, close material views and the access route. Include the project address and any plans. Photos help with initial review but do not replace any site investigation needed for a final proposal.
Can this be combined with other concrete work?
Send the complete desired result. Related cutting, removal, hauling, sitework and new concrete can be reviewed together, with each accepted part of the scope stated in the proposal.
Does 24/7 mean an immediate crew arrival?
No. Phone and email inquiries are open 24/7. Acceptance, arrival time and work hours depend on project review, travel, access, required approvals and crew scheduling.